Modern Design & Push Lever Tap
Smart Sense indicator and New Premium Push Lever Tap
Modern Design & Push Lever Tap
7-Stage Purification
Large 7 Liter Storage
Membrane Protector
*MRP (inclusive of all taxes) for 1 unit.
*Free home delivery and installation.
Smart Sense indicator and New Premium Push Lever Tap
Ensures safer than boiled water without hassle of boiling
Can purify water up to 24 Litre/Hour
Enriches water by adding essential minerals
Removes, Virus, Bacteria & Heavy metals
Ensures purified water all the time
Ensures that the RO Membrane Lasts long
7 Litre Water Storage Capacity
7.1 Kg
Upto
24 Litres per hour
Pre-Sediment
Filter, Pre RO Carbon Filter, Mesh Filter, Reverse osmosis membrane, UV
Chamber, Post RO Carbon Filter, Carbitrap
NSF
Certified - Thin film composite spiral wound
Diaphragm pump, 24V DC
Typically 60%
90% (Min.)
42 W
Min
10 PSI, Max 30 PSI
100 - 240 Vac; 50/60 Hz
Food
safe, non toxic plastics for plastic parts
1.5 metres
Upto
2000 mg/litre
500 mg/lit (max.)
0.3 mg/lit (max.)
1 NTU (max.)
Meets stringent international criteria for
microbiologically safe drinking water-e.g.,
Environmental Protection Agency (EPA), USA
Pre-Sediment filter- 2 number.
Pre-RO carbon filter- 1 number.
Mesh filter- 1 number.
Anti scalant cartridge- 1 number.
RO membrane- 1 number.
Integrated TDS + Post carbon filter- 1 number.
Stage 1st:
Pre-Sediment Filter: Removes fine & coarse particulate impurities/dirt &
improves the life of carbon filter.
Stage 2nd:
Pre-RO Carbon Filter: Removes
chlorine & organic compounds like harmful pesticides. It also absorbs bad
taste & odor causing organic compounds inside water.
Stage 3rd:
Mesh Filter: Filters
water further to ensure removal of finer particulate impurities.
Stage 4th:
RO Membrane: Removes dissolved salts, hardness, pesticides and heavy metals like lead
and mercury. It also removes microbial contaminants like bacteria, viruses,
protozoa, cyst.
Stage 5th:
UV Chamber: Acts as
an additional stage of purification to further inactivate bacteria, virus &
parasites to deliver safe water.
Stage 6th:
Post RO Carbon Filter: This level of purification acts as a polisher and enhances the taste of
purified water.
Stage
7th:
Carbitrap: Filters water
to further ensure removal of loose carbon particles.
Pureit Vital Max has
storage tank capacity of up to 6.5 to 7 liters under running water conditions. The
storage tank is fully automatic and well shielded. When you take water out of
the tank, the purification process starts automatically again and refills the
storage tank.
Pureit Vital Max can
purify water up to 24 liters per hour depending on the device you have
purchased. However, the time taken to purify depends on the life of the
filters, the input water pressure, TDS and other impurities present in water.
You need to
call the Pureit Helpline and order the consumables. The customer care
specialist will visit your place and replace the consumable/Germ kill Kit at a
nominal cost.
Pureit Vital Max will purify potable
water for removal of hardness and other impurities to give you safe drinking
water. If the input water has impurities normally not present in drinking water
(high iron/turbidity/microbial contamination etc.) or water is from unknown
resource (river /lake /pond / borewell etc.) then suitable pre-treatments may
be required.
It is not recommended to open and service device by an
individual. Call our Pureit Helpline if you face any issue which requires servicing
and opening the device.
There may be several reasons for this:
While the Germ kill Kits and the Pre-Sediment Filter have fixed replacements
schedules, depending upon your input water quality the Pre-Sediment Filter
might need a replacement even before your Purifier gives you the alert. In such
cases, please contact the Pureit Helpline and get Pre sediment Filter replaced.
The purifier will communicate the alert only if the purifier is switched on
condition during the scheduled alert time. Post the completion of the scheduled
alert time, Auto Shut off™ of water will be activated automatically, even if
the purifier is in a switched off condition.
While the Germ kill Kits™ and the
Pre-Sediment Filter have a fixed replacement schedule, you might be required to
change the filters in the interim depending on the quality of your input water.
Should the tap flow rate be very less or if it is taking too long for the tank
to fill, then please contact the Pureit helpline to change the membranes. These
extra visits will be chargeable as per T&C.
No, recommendation is to throw the first cycle of water that
is filled in the storage tank when the new Pureit purifier is installed and
whenever the Germ kill Kit is replaced.
You can use stored water for 2 days. If it is not used for
more than 2 days, we advise you to discard that water, refill and then consume.
Like other ions, the RO technology can also remove arsenic,
fluoride and nitrates.
However, RO system is not recommended for arsenic level above
0.1 mg/L, fluoride level above 8.0 mg/L and iron level
above 0.3 mg/L.
You need to replace / clean the sediment filter basis water
quality and GKK approximately every 1 year from date of installation. In case
of poor source water quality or low water line pressure few filters may need to
be replaced before 1 year and are not part of warranty.
It is not recommended to use the reject waler
for any kind of human/pets consumption (drinking
Please call the Pureit helpline - 16627. Our technicians will
visit your house and guide you on the repairs required. There will be a nominal
visiting charge and you would need to buy the parts required.
First switch off the ball valve if you find any leakage front
the purifier and turn off the power switch. Check for any visual improper
fitment and then call our Pureit helpline number and register a
service request.
Food safe, non-toxic plastics
Pre-Sediment filter- 1 number.
Pre-RO carbon filter- 1 number.
Mesh filter- 1 number.
Anti scalant cartridge- 1 number.
RO membrane- 1 number.
Integrated TDS + Post carbon filter- 1 number.
Flow restrictor 200cc- 1 number.
Meets stringent international criteria for
microbiologically safe drinking water-e.g.,
Environmental Protection Agency (EPA), USA
1.
Under test condition, Input TDS - 750 pm, Turbidity - <1
NTU, Input Pressure - 10 psi, Input Hardness - 300 ppm, Temp: - Room temp
2.
Advance Alert System will alert you 15 days before or 15
hours before completion of every 275 hours of pump running time. The purifier
will communicate the alert only if the purifier is in a switched-on condition
during the scheduled alert time. Post the completion of the scheduled alert
time, auto shut-off of water will be activated automatically for the GKK parts.
3.
Post RO purified water that's part of purification stages in
the device.
4.
Assumption: 5-member
family needing 20 litres of water every day (4 litres
per person per day)
5.
Exceeds USEPA GERM
KILL Standard guide by removing 1 crore viruses and 10 crore bacteria from
every litre of water. Pureit Vital Max has highest purification rate across
filters life when compared to leading RO brands (Kent Prime Plus and Aquaguard
Enhance RO+UV) - Under test condition, Input TDS - 750 ppm, Turbidity - <1
NTU, Input Pressure - 10 psi, Input Hardness - 300 ppm, Temp. - Room temp.
6.
6.5 to 7 liters in running water condition. Basis test report
from independent 3P lab and tested as per NSF protocol and
USEPA guidelines.
Call to Pureit Careline 09612616627 or 16627 - 8:00AM to 12:00 Midnight (everyday) or send us an email at pureit.bd@unilever.com
Regular Service Charge is 50/-
Express Service Charge is 100/-
Regular Service Charge is 200/-
Express Service Charge is 300/-